6. Insert all of the other printheads that need to be installed, and close the carriage cover.
7. Make sure that the end of the latch catches the wire loop on the near side of the carriage.
8. Lower the latch to rest on the carriage cover.
When all of the printheads have been inserted correctly and the printer has accepted them, the
printer beeps.
NOTE: If the printer does not beep when you insert the printhead and the Replace message
appears on the front-panel display, you might need to reinsert the printhead.
ENWW Work with ink system components 61
Handle the ink system
To Next Page
Loading...
