Passes Uni/bidir Self
adhesive
Banner Textile Film Syntheti
c paper
Paper
aqueous
Paper
solvent
Low
temp.
Mesh
10 Bidir Yes Yes No No No Yes Yes Yes Yes
12 Bidir Yes Yes Start
here
Maybe Maybe Yes Yes Yes Yes
16 Bidir Yes Yes Yes Start
here
Start
here
YesYesYesYes
18* Bidir Yes Yes Yes Yes Yes Yes Yes Yes Yes
20 to 32 Bidir Yes Yes Yes Yes Yes Yes Yes Yes Yes
* Unlike other printmodes, the 18-pass printmode has 1200 dpi x 1200 dpi input data resolution at 1 bpp (1
bit per pixel). Therefore, to generate a 18-pass media preset you should start either from an existing 18-pass
preset or from scratch. In the same way, do not clone an 18-pass media preset to generate a preset with a
print mode other than 18-pass.
Key
●
Bidir: bidirectional
●
No: not recommended
●
Maybe: may be worth trying for extra speed
●
Start here, Yes: recommended
NOTE: More specific settings for many substrates from different vendors are available in the HP Media
Finder at
http://www.hp.com/go/latexmediafinder/.
Check the quantity of ink on the substrate
Check that the ink quantities in your media preset are adequate. Look at the color patches in the HP
diagnostic chart and check that the patches have the correct amount of ink using the guidelines below:
1. Too much ink: There are several possible symptoms of this problem.
●
The last two or three scales of the chart look the same.
48 Chapter 5 Substrate settings ENWW
To Next Page
Loading...