Take-up reel LED status Issue Print job interrupted? Possible cause Possible solution
Solid red Take-up reel is not
winding
No There is too much
resistance on the take-
up reel motor.
Ensure that the
substrate is not winding
too tightly. A loop-
shaping core should be
inserted and hanging as
shown in the User's
guide.
Solid green Take-up reel is not
winding
No The take-up reel power
switch is in the Off
position
Ensure that the take-up
reel power switch is in
the On position.
Solid green Take-up reel is winding
in the wrong direction
No The take-up reel wind-
direction switch is in the
wrong winding position.
After 3 seconds, the
printer recognizes the
problem and interrupts
the print job. See the
first error listed in this
table.
Flip the take-up reel
wind-direction switch to
the correct position.
The following graphic shows the take-up reel sensors and cable.
1. Take-up reel sensor
2. Take-up reel sensor and cable housing unit
ENWW Take-up reel does not wind 69
To Next Page
Loading...