HP DesignJet Series - Ink Supply Station Removal Procedure

7-14
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Ink Supply Station
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7 .
2. Remove the Right End Cover
⇒ Page 7-9.
Following step only applicable to
Designjet 70, 100, 100+, 110+
3. Remove the ISS Cover ⇒ Page 7-13.
Following step not applicable to
Designjet 10ps, 20ps, 30, 30n,
50ps
4. Release the Plastic Cover protecting the
Electronics Module.
5. Disconnect the Ink Supply Station Cable
fro
m the Main PCA.