HP DesignJet Series - Page 159

7-27
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Front Panel
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7
2. Remove the Left End Cover ⇒ Page 7-11 .
3. Release the Front Panel from inside the Left
Han
d Cover.
4. Disconnect the cable from the Front Panel
and re
move from the Printer.
5. Important: When in
stalling the
Front Panel, make sure you route
the cable as shown:
2
1
The Cable MUST
go over the hook