2-4
System Error Codes
HP Designjet Ultra Low End Printer Service Manual
System Error Codes
System Error: 01:10
Problem
Description:
Electronics Module failure.
Corrective Action: Replace the Electronics Module ⇒ Page 7-18.
System Error: 01:12
Problem
Description:
Electronics Module failed during the firmware upgrade OR the Electronics
Module failed during initialization.
Corrective Action: Try the following:
If the Electronics Module failed during initialization, you must perform the
Electronics Test to determine the cause of the failure.
If the Electronics Module failed during the firmware upgrade, first perform
an emergency firmware upgrade (⇒ Page 2-26).
If an emergency firmware upgrade is NOT possible or it didn’t work,
replace the Electronics Module ⇒ Page 7-18.
System Error: 02:10
Problem
Description:
Carriage failure.
Corrective Action: Replace the Carriage Assembly ⇒ Page 7-35.
System Error: 04:13
Problem
Description:
Generic Firmware Error (Network Card).
Corrective Action: Unplug the power cable from the printer and wait a few seconds. Plug in the
power cable again and check if the Error Code has disappeared. If the error
code continues, refer to the Jetdirect Card Service Manual and Service
Notes.
System Error: 08:11
Problem
Description:
Front Panel cannot be detected.
Corrective Action: Reconnect the Front Panel.
To Next Page
Loading...