HP DesignJet Series - Page 17

2-5
System Error Codes
HP Designjet Ultra Low End Printer Service Manual
System Error: 11:10
Problem
Description:
Trailing Cable Failure.
Corrective Action: Try the following:
 Replace the Carriage Assembly ⇒ Page 7-35.
 If the Error Code continues, replace the Electronics Module ⇒ Page 7-18.
Only replace one component at a time and check if the error
has gone before replacing another component. Using this
procedure you will be able to determine exactly which
component failed.
System Error: 11:11
Problem
Description:
Trailing Cable is badly connected.
Corrective Action: Try the following:
 Reconnect the Trailing Cable correctly to the Electronics Module.
 If the Error Code continues, replace the Carriage Assembly ⇒ Page 7-35.
System Error: 21:10
Problem
Description:
Service Station failure.
Corrective Action: Replace the Service Station Assembly ⇒ Page 7-24.
System Error: 22:10
Problem
Description:
Ink Supply Station failure.
Corrective Action: Replace the Ink Supply Station ⇒ Page 7-14.
System Error: 35:01
Problem
Description:
No Cleanout Assembly detected while loading media.
Corrective Action: Try the following:
 Remove the Cleanout Assembly and install it again correctly.
 Replace the Cleanout Interconnect PCA.
 If the Error Code continues, replace the Cleanout Assembly.
Only replace one component at a time and check if the error
has gone before replacing another component. Using this
procedure you will be able to determine exactly which
component failed.