HP DesignJet Series - Page 164

7-32
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Ink Supply Tubes
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7
2. Remove the Right End Cover ⇒ Page 7-9 .
3. Release the Tubes Bracket from the Ink
Suppl
y Station by pushing the clips
inwards and lifting up the Bracket.
The following step is not applicable
to 10, 20, 30, 30n, 50ps
4. Remove 1 T-10 screw that secures the
Trailing Cable Support to the Carriage
Assembly. Release the Trailing Cable
Support from the Carriage Assembly.
5. Remove 1 T-10 screw that secures the Tube
Crane to the
Carriage Assembly.
1
2