7-36
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
10. Release the Trailing Cable Clip from the
Chassis.
11. Release the Trailing Cable from the
Chassi
s.
12. Slide the Carriage Assembly to the right
and out of
the Printer.
13. If the Carriage Assembly is to be replaced,
m
ake sure that you remove the belt (in
order to install it on the new carriage). To
remove the belt
⇒
Page 7-41.
If the Carriage is replaced by a new one, make sure that you perform the PRS
Adjustment procedure.
2
1
To Next Page
Loading...