7-52
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Pivot Assembly
(Not applicable to 10ps, 20ps, 30, 30n, 50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒
Page 7-7.
2. Remove the Left End Cover
⇒
Page 7-11.
3. Remove the Right End Cover
⇒
Page 7-9.
4.
Remove the Starwheel Assy
⇒
Page 7-43.
5. Remove 1 T-8 screw and washer that
secure the Pivot Assembly on the left hand
side of the Printer.
6.
Remove 1 T-8 screw and washer that secure
the Pivot Assembly on the right hand side of
the Printer.
To Next Page
Loading...