HP DesignJet Series - Page 193

7-61
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Pick Assembly (Applicability: 10ps, 20ps, 30, 30n, 50ps)
Removal
Switch off the product and remove the power cable.
1. Remove the Cleanout Assembly ⇒ Pa
ge 7-
31.
2. Release the locking mechanism that
se
cures the Pick Assembly on the right
hand side of the printer (looking from the
rear).
3. Release the locking mechanism that
sec
ures the Pick Assembly on the left hand
side of the printer (looking from the rear)
4. Raise the locks so that they are aligned
wi
th the cutouts and lift out the Pick
Assembly from the Printer.
1
2
1
2