HP DesignJet Series - Page 204

7-72
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Inner Paper Guide
Not applicable to 10ps, 20ps, 30, 30n, 50ps
Removal
Switch off the product and remove the power cable.
1. Remove the Cleanout Assembly ⇒ Page 7-31.
2. Remove the Top Cover ⇒ Page 7-5.
3. Remove the Center Cover ⇒ Page 7-7
4. Remove the Right End Cover ⇒ Page 7-9 .
5. Remove the Left End Cover
⇒ Page 7-11 .
6. Remove the Electronics Module ⇒ Page 7-18.
7. Remove the Power Supply Unit ⇒ Page 7-22.
8. Remove the Service Station ⇒ Page 7-24.
9. Remove the Encoder Strip ⇒ Page 7-28.
10. Remove the Ink Supply Tubes ⇒ Page 7-32.
11. Remove the Carriage Assembly ⇒ Page 7-35.
12. Remove the Pick Assembly ⇒ Page 7-62.
13. Pull the Inner Paper Guide from the middle
to r
elease it from the Printer.
14. Remove both pieces of the Inner Paper
Guide
from the Printer.