7-73
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
OOPS Sensor
Removal
Switch off the product and remove the power cable.
1.
Remove the Center Cover
⇒
Page 7-7.
2. Remove the Right End Cover ⇒ Page 7-9.
3.
Remove the Electronics Module
⇒
Page 7-18.
4.
Remove the Power Supply Unit
⇒
Page 7-22.
5. Remove the Service Station
⇒
Page 7-24.
6. Disconnect the OOPS Sensor Cable.
7. Remove the Spring that secures the OOPS
Sens
or.
Remove
To Next Page
Loading...