HP DesignJet Series - Page 209

7-77
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Paper-Axis Motor Assembly (Applicability: 90, 90r, 120,
120nr, 130, 130nr)
Removal
Switch off the product and remove the power cable.
1. Remove the Center Cover
⇒ Page 7-7.
2. Remove the Left End Cover ⇒ Page 7-11 .
3. Remove 2 T-10 screws that secure the
Pap
er-Axis Motor Assembly.
4. Disconnect the Paper-Axis Motor cable.
5. Release the belt from the Paper-Axis Motor.
Re
move the Paper-Axis Motor Assembly
from the Printer.