HP DesignJet Series - Bypass Platen Removal Steps

7-78
Removal and Installation
HP Designjet Ultra Low End Printer Service Manual
Bypass Platen (Applicability: 90, 90r, 120, 120nr, 130,
130nr)
Removal
Switch off the product and remove the power cable.
1. Remove the Cleanout Assembly ⇒ Page 7-31.
2. Remove the Top Cover ⇒ Page 7-5.
3. Remove the Center Cover ⇒ Page 7-7.
4. Remove the Right End Cover ⇒ Page 7-9 .
5. Remove the Left End Cover
⇒ Page 7-11 .
6. Remove the Electronics Module ⇒ Page 7-18.
7. Remove the Power Supply Unit ⇒ Page 7-22.
8. Remove the Service Station ⇒ Page 7-24.
9. Remove the Encoder Strip ⇒ Page 7-28.
10. Remove the Ink Supply Tubes ⇒ Page 7-32.
11. Remove the Carriage Assembly ⇒ Page 7-35.
12. Remove the Starwheel Assembly ⇒ Page 7-
43.
13. Remove the Print Platen Assembly ⇒ Page 7-
44.
14. Remove the Pivot Assembly ⇒ Page 7-52.
15. Remove the Feed Roller Assembly ⇒ Page 7-
56.
16. Remove the Pick Assembly ⇒ Page 7-62.
17.
Remove the Inner Paper Guide ⇒ Page 7-72.
18. Remove 2 T-10 screws that secure the Left
Bracket to the Chassis.