HP DesignJet Series - Page 29

2-17
System Error Codes
HP Designjet Ultra Low End Printer Service Manual
Semi-Gloss Paper and the selected print quality setting.
System Error: 941:02:4 (Only applicable to HP DesignJet 30, 30n, 90, 90r, 130, 130nr)
Problem
Description:
User selected Photo Matte Paper and Max dpi mode, but the Color
Calibration profile was obsolete or missing for Photo Matte Paper and the
selected print quality setting.
Corrective Action: Using the System Maintenance Tool, perform Color Calibration for Photo
Matte Paper and the selected print quality setting.
System Error: 941:02:5 (Only applicable to HP DesignJet 30, 30n, 90, 90r, 130, 130nr)
Problem
Description:
User selected Photo Satin Paper and Max dpi mode, but the Color
Calibration profile was obsolete or missing for Photo Satin Paper and the
selected print quality setting.
Corrective Action: Using the System Maintenance Tool, perform Color Calibration for Photo
Satin Paper and the selected print quality setting.
System Error: 94:04
Problem
Description:
Firmware Error (during color calibration).
Corrective Action: Try the following:
 Unplug the power cable from the printer and wait a few seconds. Plug in
the power cable again and check if the Error Code has disappeared.
 If the Error Code reappears, check for a new Firmware release.
System Error: 94:08
Problem
Description:
Color Calibration Warning - Color Calibration not cancelled but Color
Calibration values are likely to be incorrect.
Corrective Action: Try the Color Calibration again, but this time using a different type of media
(preferably HP media).
System Error: 94:10
Problem
Description:
Color Calibration Failure - Color Calibration cancelled.
Corrective Action: Try the following:
 Unplug the power cable from the printer and wait a few seconds. Plug in
the power cable again and try the Color Calibration again.
 If this error code appears again, check the Color Calibration print:
– If the Color Calibration was printed correctly without any print defects,
then check that the media is moving freely (backwards and forwards)
while the printer is scanning it.
– If the Color Calibration was printed incorrectly, with some print defects,