HP Designjet T1100 Series - Page 69

System Error Codes
2-9 HP Designjet T Series — Service Manual
Corrective Actions Table
The following table explains the YZ part of the System Error Code or
Warning:
93 Ink Pumping
94 Color calibration
94.1 Profiler
95 Printhead alignment
97 Paper advance calibration
Code Recovery Action Response
00 Replace
Possible for
customer to
perform
action
01 Reseat/Reconnect/Clean/Adjust (manually)
02 Calibrate/Adjust (using Automatic Process)
03 Power OFF and Restart the Printer
04 Upgrade System Firmware
05 Upgrade Driver or Computer Software
06 Add Accessory
07 Escalate
08 Send Plot Again
09 Wrong Part Installed
10 Replace
hp qualified
personnel
assistance
required
11 Reseat/Reconnect/Clean/Adjust (manually)
12 Calibrate/Adjust (using Automatic Process)
13 Power OFF
14 Upgrade System Firmware
15 Upgrade Driver or Computer Software
16 Add Accessory
17 Escalate
18 Send Plot Again
19 Wrong Part Installed
Code Component/System