HP Designjet T1100 Series - Page 70

HP Designjet T Series — Service Manual 2-10
System Error Codes - Full Descriptions
System Error Codes - Full Descriptions
This sections describes each of the system error codes and warnings that
could be encountered while using the printer and provides the remedial
action required to solve the problem detected.
Only replace one component at a time and check if the error has gone
before replacing another component. Using this procedure you will be able
to determine exactly which component failed.
System Error: 01.0:YZ
Problem
Description:
Communication with Main PCA failed.
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 Remove the formatter and reinsert it again. Ensure that it connects properly
in the Main PCA connector.
 If the System Error continues, replace the Main PCA. See Electronics
Module Main PCA and PSU (T1100/T1100ps/T610) on page 6-206 or
Electronics Module Main PCA & PSU (T1120/T112 0p s / T62 0 ) on page 6-
209.
 If the System Error continues, replace the Formatter. See Formatter on
page 6-204.
System Error: 0 1.1 : Y Z ( T 110 0 / T 110 0 p s / T 610 O N L Y )
Problem
Description:
Error in the Print Mech PCA.
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 If the System Error continues, replace the Main PCA. See Electronics Module
Main PCA and PSU (T1100/T1100ps/T610) on page 6-206 or Electronics
Module Main PCA & PSU (T1120/T1120ps/T620) on page 6-209.
3 If the System Error continues, replace the Formatter. See Formatter on page
6-204.
System Error: 01.2:YZ
Problem
Description:
Failure reading acumen chip of an Ink Supply Station.
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 Check that there are not two cartridges of the same color installed.
3 Perform the Ink Delivery System diagnostic test. See 7. I n k D e l i ve r y S y s t e m
(IDS) on page 3-35.