HP Designjet T1100 Series - Print Modes and Economy

HP Designjet T Series — Service Manual 2-18
System Error Codes - Full Descriptions
4 If the printer has a 44 inch scan axis (and a Rewinder), perform the
Rewinder diagnostic test to troubleshoot the problem further. See
6.
Rewinder on page 3-34.
5 Check that the Media Advance Drive cable is not damaged and is correctly
connected to the Main PCA.
6 Replace the Media Advance Drive. See Media Advance Drive on page 6-
224.
7 If the System Error continues, replace the Main PCA. See Starwheel
Assembly on page 6-214.
System Error: 41.1:YZ
Problem
Description:
Electrical fault or current limit in Media-Axis Motor.
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.
2 Open the Window and check for any visible obstacles restricting the
movement of the Media Advance Roller. If there is a wrinkled mass of media
inside the paper path, lift the Pinch wheels (using Media Lever) and clear the
obstruction.
3 Perform the Paper Drive diagnostic test to troubleshoot the problem furthe.
See
2. Paper Drive on page 3-18.
4 If the printer has a 44 inch scan axis (and a Rewinder), perform the
Rewinder diagnostic test to troubleshoot the problem further. See
6.
Rewinder on page 3-34.
5 Check that the Media Advance Drive cable is not damaged and is correctly
connected to the Main PCA.
6 Replace the Media Advance Drive. See Media Advance Drive on page 6-
224.
7 If the System Error continues, replace the Main PCA. See Starwheel
Assembly on page 6-214.
System Error: 42:03
Problem
Description:
Scan-Axis Motor failure (likely due to obstacles in the scan axis or electrical
fault).
Corrective Action: Try the following:
 Same as 42:YZ but after testing the issue is repeatable.
System Error: 42:YZ
Problem
Description:
Scan-Axis Motor failure (likely due to friction or obstacles in the media path).
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cord. Reconnect the power cord and power On the Printer.