Service Tests and Utilities
3-16 HP Designjet T Series — Service Manual
35 Press any key to shutdown the printer.
Cutter test
The Cutter is designed to cut roll media after printing for the size of sheet
de
fined. Before executing this test you should run the Scan Axis, Media Drive
and Carriage tests to ensure that each of these subsystems is operating
correctly.
Perform the Scan Axis - Cutter test as follows:
1 In the Diagnostics menu, scroll to 1.
Scan Axis and press OK.
2 The Front Panel will show the 1. Scan Axis submenu.
3 In the Scan Axis submenu, scroll to Cutter and press OK to start the test.
The Printer will start the Scan Axis subsystem Common Initialization and
Cu
tter test initialization. If there is a Failure at any point during the tests, the
Front Panel will display the relevant System Error Code. To trouble shoot
any displayed error codes, see
System Error Codes - Full Descriptions on
page 2-7.
4 The printer then starts the Cutter test to verify the subsystem. As the test
e
xecutes the Front Panel displays the following messages:
Starting Horsburgh and Mips.
Starting Nvm.
Starting TestsGpio.
Getting Part Number.
Starting SvsMotor.
Starting CarriageMotor.
Starting ServiceStation.
Starting ScanAxis
Moving SVS to rear bump.
Homing Scan Axis.
Move Carriage out of SVS path.
Homing Service Station.
Starting ServicingServices.
Capping Service Station.
To Next Page
Loading...