HP Designjet T Series — Service Manual 3-17
Service Tests (Diagnostics)
Uncapping Service Station.
Starting Cutter.
Starting PaperMotor.
Starting Media Sensor.
Reading Media Presence.
5 If paper is already loaded
, the printer detects the paper and continues the
test. If paper is NOT loaded, the Front Panel prompts you to load roll media.
6 Raise the Media Lever, load roll media, lower the Media Lever, and press
any key to continue.
7 The printer then starts an actual test cut of the media. As the test executes the
F
ront Panel displays the following messages:
Advance paper.
Engaging cutter.
Cutting paper.
Disengaging cutter.
8 Once the test has completed the Front Panel displays the test result and
pr
ompts you to confirm that the cutter worked.
9 Press OK if the cutter worked or BACK/CANCEL if the cutter did NOT work.
.
10 The Front Panel shows the test complete display for a few seconds.
To Next Page
Loading...