Service Tests and Utilities
3-40 HP Designjet T Series — Service Manual
8 The Front Panel prompts you to shutdown the printer to complete the test.
9 Press any key to shutdown the printer.
Check Leakage
1 In
the Diagnostics menu, scroll to 7.
IDS and press OK.
2 The Front Panel will show the 7. IDS submenu.
3 In the IDS submenu, scroll to Check Leakage and press OK to start the
test.
4 The Ink Delivery System test starts and the front Panel prompts you to remove
all the
Ink Supplies.
5 The Check Leakage test starts and the Front Panel displays the following
messages:
Starting Horsburgh and Mips
Starting Nvm
Starting Tubes
Reading Tubes status
Getting Part Number
Starting ISS Motors
Starting DDI Sensors
Moving Bongos down
To Next Page
Loading...