HP Designjet T Series — Service Manual 3-41
Service Tests (Diagnostics)
6 While the printer moves the Bongos down, the Front Panel displays the
following message:
7 If a Bongo remains in the UP position, use your finger to help push it down.
The test continues and displays the following messages:
Reading DDI Sensors
Moving Bongos up
Reading DDI Sensors
Moving Bongos down
8 The front Panel prompts you to insert all the Ink Supplies.
9 Install all the Ink Cartridges.
10 Press OK to
continue.
11 The test continues and displays the following messages:
Moving Bongos up
Checking DDI condition
12 The Front Panel then displays Check Leakage test results.
13 The Front Panel shows the test complete display for a few seconds.
To Next Page
Loading...