HP Designjet T1100 - Page 73

HP Designjet T Series — Service Manual 2-13
System Error Codes - Full Descriptions
4 If the System Error continues, replace the Service Station. See Service Station
(T1100/T1100ps/T610) on page 6-61 or Service Station (T1120/
T1120ps) on page 6-65.
5 If the System Error continues, replace the PrintMech PCA. See
PrintMech
PCA (T1100, T1100ps, T610 ONLY) on page 6-73.
System Error:
21.1:YZ
Problem
Description:
Fail moving the Primer Motor of the Service Station.
Corrective Action: Try the following:
1 Remove the Right Cover and make sure the cables from the Printmech PCA to
the Ser
vice Station are connected and are not damaged (T1100/T1100ps/
T610 ONLY).
2 P
erform the Service Station diagnostic test to troubleshoot the problem
fu
rther. See
8. Service Station on page 3-42.
3 If the System Error continues, replace the Service Station. See
Service Station
(T1100/T1100ps/T610) on page 6-61 or Service Station (T1120/
T1120ps) on page 6-65.
4 If the System Error continues, replace the PrintMech PCA. See
PrintMech
PCA (T1100, T1100ps, T610 ONLY) on page 6-73.
Warning:
2x.n:10
Problem
Description:
Ink supply error found during IDS diagnostic test. The n represents the ink
supply that is failing. The ink supply furthest to the left is always 0, and then
they count up from left to right.
Left Ink Supplies
01 2 34 5
Corrective Action: Try the following:
 Replace the Left Ink Supply Station. See Left Ink Supply Station on page 6-
183.
System Error:
22.0:YZ
Problem
Description:
Left Ink Supply Station error.
Corrective Action: Try the following:
1 Switch the Power OFF from the back of the Printer and disconnect the Power
cor
d. Reconnect the power cord and power On the Printer.