HP Designjet T Series — Service Manual 2-30
System Error Codes - Full Descriptions
roller.
A gap on the platen beam. If there’s any gap in Z (vertical direction)
between the plastic feature of the platen and the metal side plate, then
the chassis is damaged and the unit cannot be repaired.
M
e
t
a
l
sid
ep
l
a
t
e
P
la
s
t
i
c
p
la
t
e
n
Ga
p
i
n
Z
Problem
Description:
Problem with paper advance. This source of error could come from an error
in any of the following systems: paper motor, disk encoder, cables or main
electronics.
Corrective Action: Try the following:
1 Open the Window and check for any visible obstacles restricting the
mo
vement of the Drive Roller. If there is a wrinkled mass of media inside the
paper path, lift the Pinchwheels (using the Media Lever) and clear the
obstruction.
To Next Page
Loading...