HP Designjet T120 - Page 11

●
Press
to change printer settings.
●
Press
to load, unload, and change options for roll paper.
●
Press
to change options for the multi-sheet tray, or to activate it.
●
Press
to load, unload, and change options for single sheets.
●
Press
to access HP Designjet ePrint & Share.
NOTE: The active paper source is indicated by a slightly larger icon, with a white tick in a green
circle:
.
If the printer is left idle for some time, it goes into sleep mode and switches off the front-panel display.
To change the time that elapses before sleep mode, press
, then Printer preferences > Sleep.
You can set a time between 5 and 240 minutes.
The printer wakes from sleep mode and switches on the front-panel display whenever there is some
external interaction with it.
The following table shows an overview of the two types of support menu available, for more details see
Entering the support menus on page 102.
NOTE: The icons mentioned in this table will not be visible in the front panel: you must press the front
panel in the places where they normally appear, as shown in the front panel illustration at the start of
this section.
Label Description
Support menu: This can be used by customers under the
guidance of phone call agents assisting remotely. Using this
menu, customers can perform troubleshooting tasks and
access printer information.
From the Home screen, press the following icons one after the
other:
, , , .
If there is a system error, you may not be able to reach the
home screen. In this case, press the Power button and hold it
down for 15 seconds.
Extended Support menu: Service engineers only From the Home screen, press the following icons one after the
other:
, , , .
Start-up sequence
There are three states between power-on and the Home screen:
1. Electronics initialization
2. Firmware initialization
3. Mechanical initialization
ENWW
Start-up sequence
3