●
The borders of colored blocks are wrongly colored.
To correct this kind of problem:
1. Reseat the printheads by removing them and then reinserting them. See
Remove a printhead
on page 90 and Insert a printhead on page 93.
2. Align the printheads. See
Align the printheads on page 146.
Lines are discontinuous
If your lines are broken in the following way:
1. Check that you are using appropriate print-quality settings. See Printing on page 47.
2. Reseat the printheads by removing them and then reinserting them. See
Remove a printhead
on page 90 and Insert a printhead on page 93.
3. Align the printheads. See
Align the printheads on page 146.
128 Chapter 13 Troubleshooting print-quality issues ENWW
Print-quality issues
To Next Page
Loading...