3. If you would like to fine-tune the calibration or are using a transparent paper, press the Menu key
to return to the main menu and select the Image Quality Maintenance menu icon
, then Paper
advance calibration > Adjust paper advance.
4. Select the percentage of change from -100% to 100%. To correct light banding, decrease the
percentage. To correct dark banding, increase the percentage.
5. Press the OK key on the front panel, to save the value.
6. Wait until the front panel displays the status screen and re-print your print.
Return to default calibration
Returning to the default calibration sets all the corrections made by the paper advance calibration to
zero. To return to the default paper advance calibration value, you must reset the calibration.
1. Press the Menu key to return to the main menu and select the Image Quality Maintenance menu
icon
, then Paper advance calibration > Reset paper advance.
2. Wait until the front panel displays the operation has completed successfully before pressing the
back key to return to the main menu.
120 Chapter 12 Troubleshooting paper issues ENWW
Paper issues
To Next Page
Loading...