7. Primer Test Primer test on page 103.
The purpose of this test is to check the operation of the Primer.
8. Aerosol Test
Aerosol test on page 104.
The purpose of this test is to check the operation of the Aerosol Fans.
9. I/O Information
I/O Information on page 105.
The purpose of this test is to view information about input/output.
10. Unit Information
Unit information on page 105.
The purpose of this test is to view the firmware version, part number, serial number and PostScript
configuration.
11. EEROM Reset
EEROM Reset on page 106.
The purpose of this test is to reset the EEROM.
12. Hard Disk Recovery
Hard Disk recovery on page 107.
The purpose of this service utility is to clean user data on the Hard Disk, to try to recover the
printer from an unstable state.
13. File System Check
File system check on page 107.
The purpose of this service utility is to check the consistency of the file system on the Hard Disk. If
the utility detects a problem, it will try to fix it automatically.
14. OMAS Module Test
OMAS Module test on page 107.
The purpose of this test is to check the operation of the OMAS system.
Entering the Service Tests menu
NOTE: To enter the Service Utilities Menu, see Entering the Service Utilities menu on page 109.
1. Make sure the printer is switched off with the Power key on the front of the printer and not with
the power switch on the back of the printer.
2. For Call Agents who will request the user to perform certain troubleshooting actions, hold the
Down and OK keys down and turn the printer on using the Power key. Wait until you hear one
beep (usually after 5 seconds) before releasing all three keys.
ENWW
Entering the Service Tests menu
91
To Next Page
Loading...