You must perform the Paper Drive Test after:
●
System Error Code 81:YX
●
System Error Code 41:YX
●
System Error Code 73:YX
NOTE: If possible always perform this test before replacing any component of the media-axis.
1. In the Diagnostics submenu, scroll to Paper Drive and press OK.
2. The front panel asks you to unload the paper. If there is a roll loaded, unload it manually. Press
OK when done.
3. The printer performs some movement tests. The drive roller may move repeatedly during the tests.
At the end the following message will be shown if the tests succeeded:
4. Depending on the results of the tests, the front panel may display one of the following messages.
●
The printer was unable to make the test movements correctly.
●
You are asked to load paper manually, and press OK.
NOTE: Please ignore references to the lever. You may need to open and close the rear
door.
ENWW
Entering the Service Tests menu
93
To Next Page
Loading...