2. Within the Service Station submenu, select the Aerosol test.
3. The test is automatic and needs no user intervention. After the test, the printer will show that the
diagnostic result is OK, and ask you to press OK to continue. If there is any failure, an error
message will identify the part that failed.
I/O Information
This option allows you to view information about input/output.
1. In the Service Tests submenu, scroll to I/O Information and press OK.
2. The printer will start to initialize and the Front Panel will display the following messages:
●
Getting IO Interface
●
Getting Interface info
If there is a failure at this point, the Front Panel will display an error.
If no active interface is found, the Front Panel will display No active interface found. Press
any key to finish.
3. Once the IO information is obtained, it is displayed on the Front Panel. Press any key to exit.
4. Once the process is completed, OK will be displayed on the Front Panel.
Unit information
This option allows you to view the following printer information:
●
Firmware version
●
Serial number
●
Part number
●
PostScript language (if applicable)
ENWW
Entering the Service Tests menu
105
To Next Page
Loading...