3. Make sure that paper is loaded and that the Ink System is correctly installed. Press the OK key to
print the Diagnostic Print or press Cancel to exit without printing the Diagnostic Print.
4. The selected Diagnostic Print is now printed. For further information on how to use troubleshoot
print-quality problems, see
How to use the Image Quality Service Diagnostic Print on page 151.
Replace Cutter
The purpose of this Service Utility is to move the Carriage to a position where the Cutter can be
replaced easily.
Perform the Replace Cutter utility as follows:
1. In the Service Utilities submenu, scroll to Replace cutter and press OK.
2. When the following message appears on the front panel, press OK to continue with the Cutter
replacement, or Cancel to exit.
3. The Carriage moves to the Cutter replacement position and the following message is displayed on
the front panel. After a few seconds the printer will begin to shut down.
4. Before replacing the Cutter, make sure that you turn the printer off at the rear switch.
Enable/Disable Firewall
The purpose of this Service Utility is to enable or disable the firewall of the printer.
ENWW
Service utilities
115
To Next Page
Loading...