1-Pass Mode 5-Pass Mode
Paper Sensor replacement
The purpose of this Service Utility is to unload the paper and leave the Smart Roll-loading System in a
position in which the Media Sensor can be replaced easily, before powering off the printer to proceed
with the replacement.
1. In the Service Utilities submenu, scroll to Paper Sensor Replacement and press OK.
2. Check that there is no print remaining in the printer. If so, open the Window and cut the print with
a cutter or scissors, leaving the leading edge of the paper in the platen near the pinchwheels.
Press OK when done.
3. The printer begins to unload all rolls from the printer. Follow the instructions to remove all the rolls
from the printer.
NOTE: All rolls must be removed to prevent the Smart Roll-loading System from moving while
the printer is powered off and the Sensor is being changed.
4. After removing the rolls, press OK to shut down the printer. Once the printer has powered off, the
Paper Sensor can be replaced after opening the Roll Cover.
118 Chapter 5 Service tests and utilities ENWW
To Next Page
Loading...