4. If the calibration completes successfully, the front panel shows the result and prompts you to press
OK to save values; or Cancel if you prefer not to save values.
5. If the calibration fails, the front panel displays the reason.
Primer calibration
The purpose of this Service Calibration is to compute the optimum position of the Primer Assembly with
respect to the Carriage.
The calibration is a visual procedure, so you will have to remove the Right Cover before starting.
Perform the Primer Assembly as follows:
1. Remove the Right Cover
See Cover, Right on page 224.
2. Block the Maintenance Cartridge door switch in the closed position.
3. In the Service Calibrations submenu, scroll to Primer Calibration and press OK.
4. When the following message appears on the front panel, you must press OK to continue, or
Cancel to exit the calibration.
5. The calibration process starts, and the front panel shows the following message:
ENWW
Entering the Service Calibrations menu
133
To Next Page
Loading...