If your paper is not suitable for paper advance calibration, override steps 1 and 2 (Calibrate Paper
Advance) and go directly to step 3 (Adjust Paper Advance).
1.
At the front panel, select the
icon, then Paper advance calibration > Calibrate paper
advance. The printer automatically calibrates the paper advance and prints a paper advance
calibration image.
2. Wait until the front panel displays the status screen and re-print your print.
NOTE: The calibration procedure takes approximately three minutes. Do not worry about the
paper advance calibration image. The front-panel display shows any errors in the process.
●
If you are satisfied with the image quality of the print afer performing the calibration you can
stop here.
●
If you can detect an improvment in the image quality of the print but want to fine tune the
settings further, continue to step 3.
●
If you are dissatisfied with the calibration, you can return to the default calibration, refer to
the next procedure ‘Return to default calibration’ seen below.
3.
If you would like to fine-tune the calibration, select the
icon, then Paper advance
calibration > Adjust paper advance.
4. Select the percentage of change from -100% to 100%. To correct light banding, decrease the
percentage. To correct dark banding, increase the percentage.
5. Press the OK key on the front panel, to save the value.
6. Wait until the front panel displays the status screen and re-print your print.
Return to default calibration
Returning to the default calibration sets all the corrections made by the paper advance calibration to
zero. To return to the default paper advance calibration value, you must reset the calibration.
1.
At the front panel, select the
icon, then Paper advance calibration > Reset paper
advance.
2. Wait until the front panel displays the operation has completed successfully before pressing the
Back key to return to the main menu.
Visual paper advance plot
The Visual Paper Advance Diagnostic prints a test plot to check that the paper advance is operating
correctly. The plot is accessible from Service Utilities submenu> Diagnostic Print> Others> Visual Paper
Advance Diagnostic menu option. It consists of three plots printed at the left, center, and right of the
paper. These three plots are the same and contain seven numbered columns. The following illustrations
shows an example of the Visual Paper Advance Diagnostic plot.
ENWW
How to use the Image Quality Service Diagnostic Print
165
To Next Page
Loading...