4. Remove the Line Sensor from the Carriage Assembly.
5. Remove the protective foam from around the sensor.
NOTE: After installing the new Line Sensor, make sure you perform the following Service
Calibrations:
●
Line Sensor Calibration
Line Sensor calibration on page 129.
Ink Supply Tubes and Trailing Cable
Removal
WARNING! Switch off the printer and remove the power cable.
CAUTION: You MUST NEVER replace both the Hard Disk Drive and the Ink Supply Tubes and
Trailing Cable at the same time. If both parts need to replaced, you MUST first replace one part and
then power ON the printer until it completely initializes. Then you can power OFF the printer and
replace the other part.
1. Remove the Right Cover See Cover, Right on page 224.
2. Remove the Left Cover
See Cover, Left on page 227.
3. Remove the Top Cover
See Cover, Top on page 230.
4. Remove the Right Connector Cover
See Connector Cover, Right on page 236.
5. Remove the Right Rear Trim
See Rear Trim, Right on page 344.
ENWW
Disassembly order
299
To Next Page
Loading...