32. Remove the Ink Supply Tubes and Trailing Cable from the printer.
Installation of the Ink Supply Tubes and Trailing Cable
NOTE: After installing the new Ink Supply Tubes and Trailing Cable, make sure you perform the
following Service Utility:
●
Reset life counter scan cycles tubes/cable
Reset Life Counters on page 112.
ISS to Cartridge Cables
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Left Cover See Cover, Left on page 227.
2. Remove two T-20 screws from the ISS shielding.
308 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...