WARNING! Switch off the printer and remove the power cable.
1. Remove the Left Cover See Cover, Left on page 227.
2. Remove the Left Connector Cover
See Connector Cover, Left on page 237.
3. Remove the Scan-Axis Motor
See Scan-Axis Motor on page 321.
4. Remove the ISS
See Ink Supply Station (ISS) on page 310.
5. Disconnect the APS 1 (top unit) valve electrical connectors from the PrintMech PCA, and remove
the cable from the ferrite on the right-hand side of the Electronic Module.
6. Unclip the APS 1 electrical cables from the cable clamps in the left connector panel
316 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...