●
Error Code: Specific error code generated by the printer when the Printhead has been replaced.
●
Max Recovery:
◦
0: No manual Printhead recovery has been performed on the Printhead.
◦
1 or higher: At least one Printhead recovery has been performed.
Calibration status
This page contains the following information:
●
General Calibrations (performed by Service Engineers).
●
Media Specific Calibrations (performed by the User).
General calibrations
●
Printhead Alignment relates to the Printhead Alignment which changes to ‘pending’ when a
Printhead is replaced and the Printhead Alignment has not been performed.
NOTE: When a component is replaced, the corresponding calibration is NOT automatically set
to ‘NOT DONE‘. This is because the printer does not know that there is a new part installed.
●
Drop Detector relates to the Drop Detector or Service Station calibration.
●
Line Sensor relates to the Line Sensor Calibration.
Media-specific calibrations
This section shows the following for each type of media:
●
Media Name
●
Color
●
Paper Advance
26 Chapter 2 Troubleshooting ENWW
To Next Page
Loading...