3. Remove two T-15 screws from the Pinchwheel Double Lever, then remove the Pinchwheel Double
Lever.
Remove two T-15 screws from the Pinchwheel Double Lever support, then remove the Pinchwheel
Double Lever support.
Entry Platen
Removal
1. Remove the Left Rear Trim
See Rear Trim, Left on page 344.
2. Remove the Right Rear Trim
See Rear Trim, Right on page 344.
3. Remove the PW Cover
See PW Cover on page 343.
4. Disconnect two cables from the Entry Platen to the Interconnect PCA, remove a T-15 screw from the
Pinchwheel Double Lever and remove a T-15 screw from the PW Connecting Rod.
350 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...