9. Disconnect the OMAS Controller Card from the Formatter and remove it from the printer.
OMAS Cable
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 224.
2. Remove the Right Connector Cover
See Connector Cover, Right on page 236.
3. Remove the Right Smart Roll-loading System Cover
See Smart Roll-loading System Cover, Right
on page 258.
4. Remove the Service Station
See Service Station on page 244.
5. Remove the OMAS
See Optical Media Advance Sensor (OMAS) on page 353.
6. Remove one T-15 screw that secures the OMAS Cable clamp from the printer.
364 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...