5. Move the jumper from the default connection to the password reset connection.
6. Replace the cover on the EBox provisionally with a couple of screws to hold the cover in place.
7. Power up the printer and turn it on (wait until it starts up).
8. Shut down the printer and power off. Remove the power cable.
9. Remove the cover from the EBox.
10. Move the jumper from the password reset connection to the default position.
11. Cover the EBox.
NOTE: When you first start the printer with a new HDD, encrypted or not, you may see a 79:04
system error. Switch off and restart; the printer should start normally.
CAUTION: Powering off the printer while starting it with a new Formatter and HDD may corrupt the
BIOS password, leaving the printer useless because it will be unable to start.
After installing a new HDD, make sure you perform the following user calibrations:
●
Printhead Alignment
●
Paper Advance Calibration
●
Color Calibration
Power Supply Unit (PSU)
Removal
ENWW
Disassembly order
379
To Next Page
Loading...