7. Lift the Electronics Module sufficiently (approximately 2 cm) to release it from the attachments.
8. Remove the Electronics Module from the printer.
Center Platen
Removal
WARNING! Switch off the printer and remove the power cable.
1. Remove the Right Cover See Cover, Right on page 224.
2. Remove the Left Cover
See Cover, Left on page 227.
3. Remove the Top Cover
See Cover, Top on page 230.
4. Remove the Service Station
See Service Station on page 244.
5. Remove the Rear Door
See Rear Door on page 345.
6. Remove the Entry Platen
See Entry Platen on page 350.
390 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...