12. Clip the OMAS access cover back into place by sliding one edge of the cover into the slot and
then applying enough pressure to it so you can clip it into the other slot.
13. Perform the following calibrations.
●
OMAS Calibration
See OMAS Calibration on page 140.
●
Paper-advance Calibration
See Paper-advance calibration on page 124.
Encoder Disc and Sensor
Removal
WARNING! Switch off the printer and remove the power cable.
CAUTION: Please handle the Encoder Disc very carefully since any finger prints, scratches or stains
could cause the printer to malfunction.
1. Remove the Left Cover See Cover, Left on page 227.
2. Remove the Left Connector Cover
See Connector Cover, Left on page 237.
3. Remove the Ink Supply Station
See Ink Supply Station (ISS) on page 310.
4. Disconnect the Encoder Sensor cable from the PrintMech PCA.
400 Chapter 9 Printer part removal and installation ENWW
To Next Page
Loading...