4. Push down as indicated by the arrow shown below.
CAUTION: When installing the new printhead there may be some resistance, so you need to
press it down firmly but smoothly. You should hear a beep and see confirmation on the front-panel
display that the printhead has been inserted. If you have difficulty, see
Cannot insert a printhead
on page 172.
5. Insert all other printheads that need to be installed, and close the carriage lid.
6. Ensure the end of the blue handle catches the wire loop on the near side of the carriage.
126 Chapter 12 Handling ink cartridges and printheads ENWW
Ink and printheads
To Next Page
Loading...
