2. Select Unload paper.
3. Select the roll that you want to unload.
4. You may need to open the roll cover.
Roll out of paper procedure
If the end of the paper is no longer attached to the core, use the following procedure.
1. If you have already started the unload process, press the Cancel key on the front panel to cancel
that procedure.
2. Lift the blue lever on the left. If the front panel displays a warning about the lever, ignore it.
3. Pull out the paper from the printer. Pull from wherever the paper is accessible; the back of the
printer is recommended. You may need to open the roll cover.
4. Lower the blue lever.
5. If the front panel displays a warning message, press the OK key to clear it.
Load a single sheet
1. When using a T1200 series printer, ensure that the cover of roll 1 is closed. If it is opened while a
sheet is loaded, the sheet will be immediately unloaded.
2.
At the front panel, select the Paper menu icon
.
ENWW Load a single sheet 41
Paper handling
To Next Page
Loading...
