●
From the Embedded Web Server, select the Setup tab, then Printer Settings > Advanced, and
change the Cutter option.
●
From the front panel, select the Setup menu icon
, then Print retrieval > Enable cutter and
change the cutter option.
The default setting is On.
NOTE: If the cutter is turned off, it will not cut the paper between jobs, but it will continue to cut the
paper on loading, unloading and switching between rolls.
TIP: To cut roll paper while the automatic cutter is disabled, see Feed and cut the paper
on page 47.
Feed and cut the paper
If you press the Form feed and cut key on the front panel, the printer advances the paper and makes
a straight cut across the front edge. There are several possible reasons why you might want to do
this.
●
To trim the leading edge of the paper if it is damaged or not straight.
●
To feed and cut the paper when the automatic cutter has been disabled.
●
To cancel the waiting time and print the available pages immediagely, if the printer is waiting to
nest more pages (T1200 series only).
NOTE: The printheads are serviced after each print, and the paper cannot be cut until the process
completes, so you may notice a delay.
CAUTION: Remove the cut piece from the output tray. If strips or short prints are left in the output tray
the printer could jam.
NOTE: Photo and coated paper requires careful handling, see The print is scuffed or scratched
on page 162.
TIP: To move the paper without cutting it, see Move the paperon page 45.
ENWW Feed and cut the paper 47
Paper handling
To Next Page
Loading...
