●
Load two rolls of paper suitable for your jobs. If the printer finishes one roll, it will automatically
switch to the other.
●
Check that you have paper wide enough to print all of your jobs. Any jobs that are too wide may
be put “on hold for paper” if the paper mismatch action is set to Put job on hold (see
Paper
mismatch action on page 22).
●
Check the ink levels remaining in your ink cartridges.
●
When you have submitted your print jobs, you can use the Embedded Web Server from a remote
location to monitor their status.
●
Drying time should be set to Optimal.
●
Select the Setup menu icon
, then Printing preferences > Paper options > Roll switching
options > Minimize roll changes or Use roll with less paper.
We recommend the following settings, depending on the paper type and what kind of prints you are
making.
Table 7-1 Recommended settings for unattended printing
Print type Print mode MaxDetail Optimized for Drying time Paper types
Lines Normal Off Lines Optimal Coated, Bond,
Heavyweight
Coated, Glossy
Lines and fills Normal On Lines Optimal Coated, Bond,
Heavyweight
Coated, Glossy
Maps Best On Images Optimal Coated,
Heavyweight
Coated, Glossy
Renderings,
photographs
Best On Images Optimal Coated,
Heavyweight
Coated, Glossy
ENWW Unattended printing/overnight printing (T1200 series only) 67
Printing
To Next Page
Loading...
