Service engineer:
1. Remove the E-Box (see Open the E-Box on page 267) open it, and check that the hard disk’s power and
data cables are correctly connected.
2. Replace the hard disk drive. See Hard disk drive on page 276.
06.3:10 Hard disk is corrupted
Call agent:
▲
Use the power switch at the rear to turn off the printer, then disconnect the power cord.
Reconnect the power cord, then turn on the printer.
Service engineer:
1. Remove the E-Box (see Open the E-Box on page 267) open it, and check that the hard disk’s power and
data cables are correctly connected.
2. Replace the hard disk drive. See Hard disk drive on page 276.
08:04 Communication lost between front panel and formatter
Call agent:
1. Restart the printer.
2. Update the firmware.
Service engineer:
1. Check that the front panel is correctly connected.
2. Replace the front panel. See Front panel on page 281.
3. If after replacing the front panel the SE continues to appear; replace the formatter PCA. See Formatter
PCA on page 278.
08:08 A front panel icon does not work (advisory)
Service engineer:
1. Restart the printer.
2. Update the firmware.
08:10 Problems detected in the front panel Hardware
Call agent:
▲
Use the power switch at the rear to turn off the printer, then disconnect the power cord. Reconnect the
power cord, then turn on the printer.
Service engineer:
1. Check that the front panel is correctly connected.
2. Replace the front panel. See Front panel on page 281.
114 Chapter 3 System error codes ENWW
To Next Page
Loading...
