4. When you have loaded the paper, press OK. The product starts the calibration process, and displays the
results on the Front Panel if successful. Press OK to continue.
If the calibration fails, start again from the beginning. If necessary, try replacing the Line Sensor.
5. The Front Panel asks you to unload the paper. It then reminds you to reload roll paper in the normal way
and perform the full Line Sensor calibration (see The full calibration process on page 211).
Stacker overdrive calibration
The purpose of this Service Calibration is to calibrate the stacker overdrive friction against the printer.
It has to be done when:
●
Reinstalling or replacing the complete stacker.
●
When replacing the stacker overdrive motor with transmission part.
Follow these steps:
1. Prior to calibration, remove all the prints in the stacker and any paper loaded in the printer.
2. To select this calibration, go to 'stacker overdrive calibration':
3. After selecting it, press OK to start calibration.
ENWW Service Calibrations 213
To Next Page
Loading...
